The Challenges to Swim Spa Covers

Swim Spas represent distinct obstacles when it pertains to covering them.
We can all agree that the swim spa needs to be covered when not in use for all the same reasons a hot tub needs a cover. The obstacle is that because of the length of the swim spa and the height of the sides, getting rid of and changing the cover can be a lot more difficult.
Getting a brand-new swim spa is an interesting event in life. You’re anticipating the workout you’ll get from using it. Possibly you’re a little relieved to have actually lastly made a selection from the different models you looked at. At any rate, you probably weren’t thinking much about the cover you would use.
Generally, the cover that gets home with your new purchase will be a four section stiff foam filled cover that will split in the center and go off both ends.
No big deal.
Up until it starts to get heavy.
Which it always does.
Every stiff foam filled Swim Spa Cover ever made winds up the same way and it is not the fault of the user. It’s a design flaw. Built in obsolescence since as quickly as it is put in use over the warm water in your swim spa it is unavoidable.
It’s not from rain, so having a taper won’t make any distinction. In fact you might have it under a roof and the cover will still get heavy.
The reason is the steam from the water. The molecules of steam are really small as they rise from the water surface. They make their method into the little fractures and crevices in the foam. Then as the steam cools it forms back into a liquid and ends up being trapped in the cover.

It takes place gradually and on a Swim Spa Cover which is made of private sections, at differing speeds. So ultimately you’ll notice a couple of of the sections are really getting heavy. The bar lifters on the ends of the swim spa aren’t much aid because you still need to raise that heavy cover back up onto the spa which is a lot higher than a regular spa.
This is why SpaCap.com came up with a different design for their Swim Spa Covers
Instead of using several foam panels to construct Swim Spa Covers that will ultimately wind up in some garbage dump, they created one that utilizes air chambers that don’t suck up moisture.
In fact SpaCap.com Swim Spa Covers are light-weight, insulate better, won’t blow away in a wind storm or be damaged by snow or hail.
Covered with Sunbrella Marine fabric, these covers won’t fade, or break down at the joints either. So if you own a swim spa, and you intend to keep using it daily, SpaCap.com has the Swim Spa Cover for it.
If you’re not all set to order today, bookmark this site so you can discover it once again when you’re all set!

Leave a Reply

Your email address will not be published. Required fields are marked *