The Challenges to Swim Spa Covers

Swim Spas represent special challenges when it concerns covering them.
We can all agree that the swim spa has to be covered when not in use for all the same reasons a hot tub requires a cover. The challenge is that because of the length of the swim spa and the height of the sides, eliminating and changing the cover can be a lot harder.
Getting a new swim spa is an exciting occasion in life. You’re eagerly anticipating the workout you’ll receive from using it. Perhaps you’re a little relieved to have actually lastly selected from the different models you looked at. At any rate, you probably weren’t believing much about the cover you would use.
Generally, the cover that gets back with your new purchase will be a 4 area rigid foam filled cover that will split in the center and go off both ends.
No big deal.
Till it begins to get heavy.
Which it constantly does.
Every stiff foam filled Swim Spa Cover ever made winds up the same way and it is not the fault of the user. It’s a style defect. Integrated in obsolescence because as soon as it is put in use over the warm water in your swim spa it is inescapable.
It’s not from rain, so having a taper will not make any distinction. In fact you might have it under a roof and the cover will still get heavy.
The factor is the steam from the water. The molecules of steam are extremely small as they rise from the water surface. They make their method into the little fractures and crevices in the foam. Then as the steam cools it forms back into a liquid and becomes trapped in the cover.

It happens gradually and on a Swim Spa Cover which is made of individual areas, at differing speeds. So eventually you’ll observe one or two of the sections are truly getting heavy. The bar lifters on completions of the swim spa aren’t much assistance since you still have to lift that heavy cover back up onto the spa which is a lot higher than a regular spa.
This is why SpaCap.com created a new design for their Swim Spa Covers
Instead of using several foam panels to develop Swim Spa Covers that will ultimately wind up in some landfill, they designed one that utilizes air chambers that don’t suck up moisture.
In fact SpaCap.com Swim Spa Covers are lightweight, insulate better, won’t blow away in a wind storm or be damaged by snow or hail.
Covered with Sunbrella Marine fabric, these covers won’t fade, or break down at the seams either. So if you own a swim spa, and you intend to keep using it daily, SpaCap.com has the Swim Spa Cover for it.
If you’re not prepared to purchase today, bookmark this website so you can find it again when you’re all set!

Leave a Reply

Your email address will not be published. Required fields are marked *